Meter and service cupboards

The cupboard on the landing that holds the meters is usually the most holed wall in the building.

  • Every seal labelled and photographed
  • BM TRADA / FIRAS-certificated contractors
  • Written price before any work
Get a price

We reply with a written price.

We use these details to reply to you. See our privacy notice.

In an Islington mansion block or a 1960s estate block, every landing tends to have a cupboard in the wall of the stair or the corridor, with the electric meters for the flats on that floor and sometimes the gas meters too. The back and side walls of the cupboard are often the only thing between the escape route and a flat. Every meter tail, gas pipe and water pipe that leaves the cupboard goes through one of those walls.

One of the jobs our team has finished elsewhere was exactly this, a gas meter cupboard in a block of flats where the services passing out of the cupboard were sealed.

Cables and a cable tray under a concrete slab, with one cable dropping through a slot at the top of a painted wall
Cables and a cable tray under a concrete slab, with one cable dropping through a slot at the top of a painted wall

What is usually found

On an older landing the cupboard might hold four electric meters with their tails running through a single hole at the back that has been opened up every time a supply was changed, so it is now 120mm across with a gap round the cables. A gas pipe for each flat leaves through its own sleeve, often with an open ring round the sleeve. There may be a water main, a door entry cable and a TV feed as well, each with its own drilled hole. Above it all, the top of the cupboard may be open to a ceiling void that runs over the flat next door.

How it is sealed

On the record one cupboard can easily be six or seven lines. Electrical cables through a large opening take a coated batt cut round them with mastic at the edges, or a sealant tested for cable bundles if the hole is small. Gas sleeves are sealed round the outside of the sleeve only. Gas pipes and meters are never worked on by our contractors, and anything that looks wrong with them is reported for a Gas Safe engineer. Water pipes take mastic or a wrap depending on the material.

Access

Meter cupboards are often locked with a utility key or a padlock that the managing agent holds. It saves time to send a key list and to tell us which floors have gas.

Cupboard sealing is carried out by our BM TRADA / FIRAS-certificated contractors.

Has your fire risk assessment flagged fire stopping?

Send the action from the assessment or a few photos of the gaps, with the postcode. We reply with what the job involves and a written price.

Call 020 3535 7563Get a quote